Move over jack-o-lanterns because pup-o-lanterns are all the rage this year!
I love my dogs and what better way to show off my love for them than to carve their face (or at least as close as I could) into a pumpkin for Halloween.
My pup-o-lantern may have started off as just a regular, orange pumpkin, but it definitely had a dream of being transformed into something special. All I needed was a pumpkin, a stencil, a small carving knife, a pumpkin shaver, some tape and a whole lot of determination.
To begin, I started by cutting off the top of my pumpkin and cleaning out the middle. Honestly, this part of the process is the longest and definitely most labor intensive as well. However, making sure that your pumpkin’s inside is clean is most important because you don’t want any stringy bits obscuring all your hard work.
Next, I taped my stencil to the front surface of my pumpkin and used my knife to make a shallow dotted line along the stencil lines so that I would know where exactly to cut. You could, of course, leave the stencil on while you carve your pumpkin, but this can be difficult since pumpkin juice can make your paper stencil rip and tear. I found a pit bull stencil off of the sheknows website, who kindly put together a slideshow of 19 printable dog patterns for carving. I did end up enlarging the stencil though, because otherwise a few of the lines were a little too close together for comfort.
Then I took my carving knife and carefully cut out all the sections that were cut out (the dark grey parts of the stencil), and continued on to shave the sections indicated (the light grey sections of the stencil). While I did use a fancy-ish carving knife and shaver, any knife should work. Although, I did find that a smaller, thinner knife did help me cut the more detailed areas easier.
Finally, all I had left to do was put in a couple LED electric candles in my pup-o-lantern and wait for the sun to set.
So, whether you are ambitious enough to use a stencil to carve your own pup-o-lantern or stick to simple shapes to make a basic face or paw print (because really that’s just a cluster of ovals), any pup-o-lantern is sure to be awesome!